Installation

Cut 1m or longer sections of tubing

Boil some water and put in a bowl you can take to site

Put the cut end into boiling water for a minute or so

While holding the tee, rotate the tubing onto the tee

Repeat to build your chain of Ollas

Using appropriate connector, connect input end to water tank

Listen for water filling the ollas

It's satisfying to see the fill line rise

Clamp open end and leave for 24h to check for leaks

Place the ollas where you want them

Dig holes to seat ollas with just top exposed (or even slightly deeper)

Cut 4mm tubing leaving slack so you can run it easily

Cut and use joiners to add segments, if required

Connect to tank

Connect tap to outlet end

Wait until water comes out of the outlet tap

Close outlet tap